Click below to email us

12V photoswitch

12V photoswitch
12V photoswitch
Product Code: AA0323
Availability: Out Of Stock
Price: $23.95
Quantity:   Out Of Stock

12V photoswitch to switch lamps or other electric devices on or off at dusk or dawn

This photo-switch (light-sensitive switch) senses the ambient light level and will switch external devices on or off at night and in the morning, depending on which leads are connected to the device.It is called a 'Twilight Switch" by the manufacturer as its primary use is in switching power on and off at dawn and dusk.
The control circuit must be powered by 11V - 14V, power consumption is only 2mA / 35mA (relay off/on) so it can be powered by a small 12 volt battery.
The maximum power supply that can be controlled by the photo switch is 25 Volts / 3 Amps.
The switching relay has a delay of approximately 3 to 4 seconds after the photocell has registered a change in light level.
Common uses are for garden lighting and security applications. The sensitivity of the optical sensor (the clear lens on the device) can be altered by partially covering it.

Assembly instructions and setting into operation:
The module should be mounted in a dry place (e.g. roof projection) in such a manner that the lamp which is turned on by the crepuscular switch does not illuminate the crepuscular switch itself! In this case the crepuscular will switch ON and OFF constantly! A switching delay of approx. 3…4 seconds is installed to avoid that the crepuscular switch reacts to short changes of the lighting conditions (e.g. passing headlamps). The device is operated with an operating voltage of 12 V= (either a 12 V car battery or a stabilised 12 V power supply). The device has a relay contact 1 x SWITCH OVER. So you may either switch a lamp or device on at dusk or switch it off! Please make sure that the power consumption of the connected devices is < 3 ampere (maximum breaking capacity of the relay). If you think that the module switches too late (approx. 45 lux), you may change the switching threshold by covering the optical sensor (the clear lens on the device) partially with opaque adhesive tape.

 Technical data:

  • Operating voltage: 12 V DC voltage (11...14 V)
  • Power consumption: approx. 2 mA / 35 mA (relay on / off)
  • Relay contact: 1 x switch-over, loading capacity max. 25 V 3 A
  • Operating temperature range: approx. - 15...+ 50 degree C
  • Luminous intensity switching-on: approx. 25 lux ± 20 %
  • Luminous intensity switching-off: approx. 45 lux ± 20 %
  • Switching delay: approx. 3...4 seconds
  • Dimensions: approx. 72 x 50 x 32 mm (without fixing straps)